PA6 Specifications

The PA6 is designed to connect passive piezo sensors, used in most hydrophones, to professional-grade microphone preamplifiers. These include preamps that are built into digital recorders, high-quality computer sound interfaces, PA systems, and mixing consoles. The PA6 will also be useful for many other sensors, such as geophones, accelerometers, contact microphones, and any device requiring a low-noise, high-impedance buffer that works within the human auditory spectrum and above.

Phantom power is required. 48V is the standard but the PA6 is designed to work with supplies as low as 24V with negligible performance difference.

NOTE: This amplifier is not waterproof. Care should be taken to keep connectors and electrical components as dry as possible, especially when working in corrosive environments such as seawater or chlorinated water.

Default board setup: 26dB gain, differential output, P48 phantom-powered

Equivalent Input Noise -120 dBV 10nF input shunt, A-weighted 20Hz – 22kHz, 1KΩ output load
Total Broadband Output Noise -88 dBV 10nF input shunt, Unweighted 10Hz – 90kHz, 1KΩ output load
Bandwidth 14Hz - 90 kHz +0/-0.5 dB, 1KΩ output load
4Hz - 270 kHz +0/-3 dB, 1KΩ output load
THD+N <0.01% @1kHz, -60 to -20 dBV input, 1KΩ output load
Max output >8dBV RMS @1kHz, 1KΩ output load, 1% THD
Current consumption 8.5 mA 48V Phantom Power (from mic preamp)
3.4 mA 24V Phantom Power (from mic preamp)
Gain 26dB Differential: pins 2 & 3 (Standard—can be factory-modified)
Z out 17 Ω Each phase to ground
Z in 10 MΩ (Standard—can be factory-modified to filter low frequencies)
Physical Ø19.7mm x 66.8mm, 42g. (Built on Switchcraft AAA3MZ connector)